Apple Pencil Gen 2nd
Preparation
1.Prepare your table: A flat, clean surface - avoid dust, hairs and leftovers on the table. Prepare your hands: wash your hands with soa and water to remove all the natural oils from your hands, and then dry your hands thoroughly.
2.Prepare your device: Use slightly damp cloth to wipe the surfaces where the skin will be applied.
3.Let dry completely: Wait a few minutes to make sure that all water has evaporated. This is key. If the device is wet, the skin will be harder to be applied and the glue may not activate correctly. Have your hairdryer ready.
Apply the skin
The skin comes with three elements: pencil tip, body and the little dot. Two sets are included, just in case you mess up with your first try.
1. Begin with the tip piece.
You need to align the skin along the edge between the tip and the pencil body, be sure align it properly, so the next steps will go easy.
2. once aligned correctly, continue wrapping around the tip of the pencil. Now use a hairdryer to heat it up, and then apply firm pressure to smooth out any wrinkles.
3. next move on to the body.
To get a perfect installation, line up the skin against the edge of the flat surface on the pencil, once you have the initial alignment, continue wrapping the skin around the pencil by applying pressure from the center outwards.
4. Leaving the tiny flaps unstuck, then use a hairdryer heating it up from the top down, once the skin(tiny flaps) softens, wrap the flaps inward.
5. Move on to the dot. Position the dot on the top of the pencil, then heat it up and apply firm pressure to secure it in place.
Enjoy!